AASHTO M 107-09 is identical to ASTM B22-08.
1. Scope
1.1 This specification establishes requirements for bronze
castings for turntables, movable bridges and bridge parts, and
bronze castings suitable for use in bridges and other structures
for fixed and expansion bearings in which motion is slow and
intermittent. The following Copper Alloys are specified: UNS
No. C86300, C90500, C91100, C91300, and C93700.
NOTE 1--Historically, the alloys in this specification have been used in
the applications listed in Appendix X1. Actual practice may vary.2
1.2 The values stated in either SI units or inch-pound units
are to be regarded separately as standard. The values stated in
each system may not be exact equivalents; therefore, each
system shall be used independently of the other. Combining
values from the two systems may result in non-conformance
with the standard.
1.3 This standard does not purport to address all of the
safety concerns, if any, associated with its use. It is the
responsibility of the user of this standard to establish appropriate
safety and health practices and determine the applicability
of regulatory limitations prior to use.
A Summary of Changes section appears at the end of this standard.
| Number of Pages : | 5 |
| Published : | 01/01/2009 |
