Name:
AGMA 01FTM9 PDF
Published Date:
10/01/2001
Status:
[ Active ]
Publisher:
American Gear Manufacturers Association
Unique tooth geometry that might be difficult or even impossible to achieve with cut gears can be applied to molded gears. This paper will investigate two types of gears that have been designed, molded and tested in plastic. The first is an asymmetric mesh with dissimilar 23 and 35 degree pressure angles. The second is an orbiting transmission with a 65 degree pressure angle. Both transmissions have higher load potential than traditional design approaches.
| Edition : | 01 |
| File Size : | 1 file , 330 KB |
| Number of Pages : | 11 |
| Published : | 10/01/2001 |
