AGMA 917-B97 PDF

Published Date: 09/25/1997

Design Manual for Parallel Shaft Fine-Pitch Gearing

Published Date: 09/25/1997

Design Manual for Parallel Shaft Fine-Pitch Gearing

Published Date: 10/01/2015

Influence of Surface Finishing on the Load Capacity of Coated and Uncoated Spur Gears

Published Date: 10/01/2019

Micro-skiving - (r)evolution of a Known Production Process

Published Date: 04/16/2002

Inspection Practices - Part 1: Cylindrical Gears - Tangential Measurements

Published Date: 10/01/2010

Low Distortion Heat Treatment of Transmission Components

Published Date: 04/26/2006

Short-circuit currents - Calculation of effects - Part 2: Examples of calculation.

Published Date: 02/09/2005

Insulating materials - Industrial rigid laminated sheets based on thermosetting resins for electrical purposes - Part 4: Typical values

Published Date: 02/17/2010

Short-circuit currents in three-phase a.c. systems - Part 2: Data of electrical equipment for short-circuit current calculations.

Published Date: 06/28/2006

Electromagnetic compatibility (EMC) - Part 2-8: Environment - Voltage dips and short interruptions on public electric power supply systems with statistical measurement results (IEC/TR 61000-2-8:2002)

Published Date: 07/19/2006

Electromagnetic compatibility (EMC) - Part 3: Limits - Section 6: Assessment of emission limits for distorting loads in MV and HV power systems - Basic EMC publication (IEC/TR 61000-3-6:1996)

Published Date: 03/15/2006

Safety requirements for electrical equipment for measurement, control, and laboratory use - Part 3: Protocol for the preparation of conformity verification reports for the IEC 61010 2nd edition series .