AIA NASM35203 PDF

Published Date: 12/29/2023

SCREW, MACHINE, FLAT COUNTERSUNK HEAD, 82°, CRUCIFORM RECESS, ALUMINUM ALLOY, ANODIC COATED, UNF-2A

Published Date: 02/29/2012

SCREW, MACHINE, FLAT COUNTERSUNK HEAD, 82°, CRUCIFORM RECESS, ALUMINUM ALLOY, ANODIC COATED, UNF-2A

Published Date: 02/29/2012

SCREW, MACHINE, FLAT COUNTERSUNK HEAD, 82°, CRUCIFORM RECESS, ALUMINUM ALLOY, ANODIC COATED, UNF-2A

Published Date: 10/01/1998

Screw, Machine-Flat Countersunk Head, 82 Degree, Cross-Recessed, Aluminum Alloy, Anodic Coated, UNF-2A

Published Date: 04/29/2022

LOCKNUT, BEARING RETAINING

Published Date: 10/31/2016

BOLT, TENSION, CLOSE TOLERANCE, SPLINE DRIVE, A286 CRES, 1250 MPa, METRIC

Published Date: 05/31/2023

FASTENER TEST METHODS METHOD 25 DRIVING RECESS TORQUE QUALITY CONFORMANCE TEST

Published Date: 01/01/1991

Specification - Flares, Landing

Published Date: 02/09/2011

Petroleum and natural gas industries — Equations and calculations for the properties of casing, tubing, drill pipe and line pipe used as casing or tubing (ISO/TR 10400:2007)

Published Date: 10/25/2021

Petroleum and natural gas industries — Formulae and calculations for the properties of casing, tubing, drill pipe and line pipe used as casing or tubing (ISO/TR 10400:2018)

Published Date: 05/25/2022

Ergonomic design of control centres - Part 10: Introduction to the control room design series of standards (ISO/TR 11064-10:2020)

Published Date: 12/02/2022

Best practices for the creation/evaluation of fingerprint analysis in accordance with the ISO 28199 series (ISO/TR 11594:2022)

Published Date: 04/15/2004

Protective clothing — Vocabulary (ISO/TR 11610:2004)

Published Date: 08/15/2012

Nanotechnologies — Guidance on methods for nano- and microtribology measurements (ISO/TR 11811:2012)