Name:
ASTM A370-12a PDF
Published Date:
10/15/2012
Status:
Active
Publisher:
ASTM International
1.3 Annexes covering details peculiar to certain products are appended to these test methods as follows:
|
| Annex |
| Bar Products | |
| Tubular Products | |
| Fasteners | |
| Round Wire Products | |
| Significance of Notched-Bar Impact Testing | |
| Converting Percentage Elongation of Round Specimens to | |
| Testing Multi-Wire Strand | |
| Rounding of Test Data | |
| Methods for Testing Steel Reinforcing Bars | |
| Procedure for Use and Control of Heat-Cycle Simulation |
1.5 When this document is referenced in a metric product specification, the yield and tensile values may be determined in inch-pound (ksi) units then converted into SI (MPa) units. The elongation determined in inch-pound gauge lengths of 2 or 8 in. may be reported in SI unit gauge lengths of 50 or 200 mm, respectively, as applicable. Conversely, when this document is referenced in an inch-pound product specification, the yield and tensile values may be determined in SI units then converted into inch-pound units. The elongation determined in SI unit gauge lengths of 50 or 200 mm may be reported in inch-pound gauge lengths of 2 or 8 in., respectively, as applicable.
1.6 Attention is directed to ISO/IEC 17025 when there may be a need for information on criteria for evaluation of testing laboratories.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| File Size : | 1 file , 710 KB |
| Note : | This product is unavailable in Russia, Ukraine, Belarus |
| Number of Pages : | 48 |
| Published : | 10/15/2012 |
| Redline File Size : | 2 files , 1.7 MB |
