ASTM A530/A530M-02 PDF

1.1 This specification covers a group of requirements which, with the exceptions of Section 4.3, Section 12, Section 19, and Section 20, are mandatory requirements to the ASTM pipe product specifications noted below unless the product specification specifies different requirements, in which case the requirement of the product specification shall prevail.

1.2 Sections 4.3 or 19 are mandatory if the product specification has a requirement for product analysis or flattening tests.

1.3 Section 20 is mandatory if the product specification has a hydrostatic test requirement without defining the test parameters.

1.4 Section 12 is for information only.

1.5 In case of conflict between a requirement of the product specification and a requirement of this general requirement specification, only the requirement of the product specification need be satisfied.

These designations refer to the latest issue of the respective specifications.

Title of Specification ASTM DesignationSeamless Carbon Steel Pipe for High-TemperatureServiceA 106Metal-Arc-Welded Steel Pipe for Use With High-Pressure Transmission SystemsA 381Centrifugally Cast Ferritic Alloy Steel Pipe for High-Temperature ServiceA 426Centrifugally Cast Austenitic Steel Pipe for High-Temperature ServiceA 451Seamless Carbon Steel Pipe for Atmospheric and Lower TemperaturesA 524Centrifugally Cast Iron-Chromium-Nickel High-AlloyTubing for Pressure Application at High Temperatures A 608 Centrifugally Cast Carbon Steel Pipe for High-Temperature ServiceA 660Electric-Fusion-Welded Steel Pipe for Atmospheric and Lower Temperatures A 671Electric-Fusion-Welded Steel Pipe for High-Pressure Service at Moderate TemperaturesA 672 Carbon and Alloy Steel Pipe, Electric-Fusion-Weldedfor High-Pressure Service at High Temperatures A 691 Centrifugally Cast Ferritic/Austenitic Stainless SteelPipe for Corrosive Environments A 872

1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the "M" designation (SI) of the product specification is specified in the order.

Note 1 - The dimensionless designator NPS (nominal pipe size) has been substituted in this standard for such traditional terms as "nominal diameter," "size," and "nominal size."

File Size :	1 file , 69 KB
Note :	This product is unavailable in Russia, Ukraine, Belarus
Number of Pages :	8
Published :	09/10/2002