Name:
ASTM B395/B395M-08 PDF
Published Date:
04/01/2008
Status:
Active
Publisher:
ASTM International
1.1 This specification establishes the requirements for condenser, evaporator, and heat exchanger U-bend tubes that are manufactured from seamless copper and copper alloy tube.
1.2 The following safety hazard caveat pertains only to the test methods described in this specification.
1.2.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
1.3 Units - The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This specification is applicable to product 2 in. [50 mm] or less, inclusive, in diameter.
1.5 The product shall be produced from one of the following coppers or copper alloys, as specified in the ordering information:
A Designations listed in Classification B 224.
| File Size : | 1 file , 150 KB |
| Note : | This product is unavailable in Russia, Ukraine, Belarus |
| Number of Pages : | 12 |
| Published : | 04/01/2008 |
| Redline File Size : | 2 files , 270 KB |
