ASTM C230/C230M-13 PDF

1.1 This specification covers requirements for the flow table and accessory apparatus (Note 1) used in making flow tests for consistency of mortars in tests of hydraulic cement, such as but not limited to Test Method C1437.

Note 1-To help clarify the design of the flow table and accessory apparatus see the drawing in Fig. 1 [Fig. 2]. This drawing is for informational purposes only.
FIG. 1 Flow Table and Accessory Apparatus (Partial) (in./lb)
FIG. 1 Flow Table and Accessory Apparatus (Partial) (in./lb) (continued)
FIG. 2 Flow Table and Accessory Apparatus (Partial) [SI]
FIG. 2 Flow Table and Accessory Apparatus (Partial) [SI] (continued)
FIG. 2 Flow Table and Accessory Apparatus (Partial) [SI] (continued)

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. It is permissible to use an inch-pound caliper and mold with a SI flow table or a SI caliper and mold with an inch-pound flow table. It is not permissible to mix a SI mold with an inch-pound caliper or an inch-pound mold with a SI caliper.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

File Size :	1 file , 180 KB
Note :	This product is unavailable in Russia, Ukraine, Belarus
Number of Pages :	6
Published :	06/01/2013
Redline File Size :	2 files , 460 KB