1.1 These test methods cover tests for solvent containing varnishes primarily intended to provide electrical, mechanical, and chemical protection for electrical equipment. These test methods include tests for control and performance as follows:
Procedure Section Build 38 - 42 Dielectric Strength 43 - 48 Drainage 26 - 32 Flash Point 18 - 20 Nonvolatile Matter 21 - 25 Oil Resistance 54 - 56 Preparation of Test Specimens 7 Specific Gravity 9 - 12 Temperature Index 49 - 50 Time of Drying 33 - 37 Varnish Compatibility 51 - 53 Viscosity 13 - 17
1.2 Where the entire test method is included in this standard, the precision and bias are not known unless given in the stated method.
1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 5.
Note 1: There is no equivalent IEC standard.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| File Size : | 1
file
, 310 KB |
| Note : | This product is unavailable in Russia, Ukraine, Belarus |
| Number of Pages : | 9 |
| Published : | 03/01/2024 |
