ASTM D228/D228M-09e1 PDF

1.1 These test methods cover procedures for sampling, examination, physical testing, and analyses of asphalt-containing materials used in roofing and waterproofing. These materials include but are not limited to roll roofing, cap sheets, and shingles. Any of these materials are allowed to be partially or fully coated, surfaced, or laminated, or a combination thereof.

1.2 The test methods and procedures in this standard appear in the following order:

SectionContent 6Types of Roofing 7Sampling 8Mass and Area Determination 9Selection of Representative Specimens 10Moisture 11Pliability 12Mass Loss and Behavior on Heating 13Tear Strength 14Fastener Pull-Through Resistance 15Preparation and Selection of Small Test Specimens
for Analyses 16Analysis of Glass Felt Products 17Analysis of Roofing Products with Organic Felts 18Ash of Desaturated Felt 19Calculation 20Adjusting Back Coating Fine Mineral Matter and
Back Surfacing 21Report 22Precision and Bias

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

File Size :	1 file , 290 KB
Note :	This product is unavailable in Russia, Ukraine, Belarus
Number of Pages :	13
Published :	12/01/2009