ASTM D2978-15e1 PDF

1.1 These test methods cover the measurement of the volume of loose and baled processed peat expressed as cubic feet and is used as a quality control measurement to determine if the package contains the labeled amount of material. The results of these test methods are highly dependent on the experience of the personnel running the procedure.

1.2 There are two test methods, Method A for Loose Peat and Method B for Baled Peat. Method A is used when the material is uncompacted and Method B is used when the material is compacted.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses after inch-pound units are provided for information only and are not considered standard. Except, that the sieve designations are typically identified using the “alternative” system in accordance with Practice E11, such as 3-in. and No. 200, instead of the “standard” of 75-mm and 75-µm, respectively.

1.4 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.