1.1 This test method covers the determination of puncture properties of rigid plastics over a range of test velocities. 1.2 Test data obtained by this test method are relevant and appropriate for use in engineering design. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: This standard and ISO 6603-2 address the same subject matter, but differ in technical content. The technical content and results shall not be compared between the two test methods. 1.5
This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | File Size : | 1
file
, 450 KB |
| Note : | This product is unavailable in Russia, Ukraine, Belarus |
| Number of Pages : | 11 |
| Published : | 11/01/2023 |
| Redline File Size : | 2
files
, 710 KB |
