ASTM D5329-20 PDF

1.1 These test methods cover tests for hot-applied types of joint and crack sealants and fillers for portland cement concrete and asphaltic concrete pavements. There are numerous standard material specifications that use these test methods. Refer to the respective standard material specification of interest to determine which of the following test methods to use. For sample melting and concrete block preparation, see their respective standard practices.

1.2 The test methods appear in the following sections:

Section

Artificial Weathering

13

Asphalt Compatibility

12

Bond, Non-Immersed

8

Bond, Water-Immersed

9

Cone Penetration, Non-Immersed

6

Flexibility

15

Flow

7

Resilience

10

Resilience, Oven-Aged

11

Tensile Adhesion

14

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.