ASTM D6511/D6511M-18(2024) PDF

1.1 These test methods cover procedures for sampling and testing solvent bearing bituminous compounds for use in roofing and waterproofing. 1.2 The test methods appear in the following order:   Section Sampling 4 Uniformity 5 Weight per gallon 6 Nonvolatile content 7 Solubility 8 Ash content 9 Water content 10 Consistency 11 Behavior at 60 °C [140 °F] 12 Pliability at -0 °C [32 °F] 13 Aluminum content 14 Reflectance of aluminum roof coatings 15 Strength of laps of rolled roofing adhered with roof adhesive 16 Adhesion to damp, wet, or underwater surfaces 17 Mineral stabilizers and bitumen 18 Mineral matter 19 Volatile organic content 20 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

File Size :	1 file , 490 KB
Note :	This product is unavailable in Russia, Ukraine, Belarus
Number of Pages :	9
Published :	05/01/2024