ASTM D8015-15(2019) PDF

1.1 This standard gives the testing procedure to determine the change in dimensions of specimens of rubber or elastomeric materials, or both, resulting from exposure to gaseous hydrocarbon environments. The size of the specimens is such to facilitate preparation from as molded component configurations such as gaskets and seals. Where agreed to by both parties molded specimens may be used. Dimensional measurements are made prior to and after conditioning in a formulated test gas.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.