ASTM F1199-21 PDF

1.1''This specification covers all cast strainers and welded strainers in services up to 150 psig and 150''F (1 MPa and 65''C). For welded strainers used in services above 150 psig and 150''F, see Specification F1200.

1.2''This standard provides the minimum requirements for the design, fabrication, rating, marking, and testing of cast and welded pipe line strainers for services above 0''F ('''18''C).

1.3''Strainers manufactured to this specification are acceptable for use in the marine environment.

1.4''The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5''The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.