1. Scope
1.1 This specification covers requirements and test methods for annular, corrugated profile wall
polyethylene pipe and fittings with an interior liner. The nominal inside diameters covered are 150 to 1500 mm [6 to
60 in.].
1.2 The requirements of this specification are intended to provide pipe and fittings suitable for underground use
for non-pressure sanitary sewer systems. Pipe and fittings produced in accordance with this specification shall be
installed in compliance with Practice.
1.3 This specification covers pipe and fittings with an interior liner using a corrugated exterior profile.
1.4 Units - The values stated in either SI or inch-pound units are to be regarded separately as standard. Within the
text the Imperial (inch-pound) units are shown in brackets. The values stated in each system may not be exact
equivalents: therefore, each system shall be used independently of the other. Combining values from the two systems
may result in non-conformance with the standard.
1.5 The following precautionary caveat pertains only to the test method portion, Section 7, of this specification. This standard does not purport to address all of the safety concerns,
if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate
safety and health practices and determine the applicability of regulatory limitations prior to use.
| File Size : | 1
file
, 110 KB |
| Note : | This product is unavailable in Russia, Ukraine, Belarus |
| Number of Pages : | 6 |
| Published : | 05/01/2012 |
