ASTM F3264-17 PDF

1.1.1 This specification identifies the industry standards which have been determined by consensus to demonstrate compliance to the requirements (“the Rules”) for Level 1, 2, 3, 4 Normal Category Aeroplanes.

1.1.2 Unless specifically defined otherwise, the herein referenced specifications are only applicable to the aeroplanes defined in 1.1.1.

1.1.3 Only standards that are considered mature enough for general application to certification projects and have been found acceptable by committee consensus to propose to the CAAs for acceptance as a Means of Compliance to their Rules are included.

1.1.4 In the event that a particular CAA's requirements are not harmonized with the other CAA's requirements, the standards will be written to include the non-harmonized requirements as well as the harmonized requirements with the applicability defined in the standard.

1.2.1 CAAs may accept a specific revision of this specification as an acceptable Means of Compliance (MoC) to their requirements. Acceptance and applicability as a MoC to the CAA's airworthiness rules remains the decision of the respective CAAs. CAAs may accept this specification, with or without limitations as defined in their specification acceptance document. For information on which CAAs have accepted these standards (in whole or in part) as an acceptable MoC to their Rules, refer to the ASTM F44 webpage (www.astm.org/COMMITTEE/F44.htm) which includes CAA website links.

1.3.1 The applicant must seek individual guidance from their respective CAA concerning the use of this specification and any referenced Specifications, Practices, Test Methods, or Guides to show compliance to the CAA rules. Alternatively, an applicant may propose a MoC other than those included in this specification but it is their responsibility to obtain approval of their proposed MoC from their CAA.