This standard describes the manufacture of concrete pressure pipe, reinforced with a steel cylinder that is helically wrapped with mild steel bar reinforcement, in sizes ranging from 10 in. through 72 in. (250 mm through 1,830 mm), inclusive, and for working pressures up to 400 psi (2,760 kPa). Larger pipe sizes and pipe accommodating higher pressures have been manufactured based on the concepts of this standard. With agreement by the purchaser and the manufacturer, pipe may be manufactured to larger sizes and for higher pressures than indicated herein. This standard does not include requirements for design, handling, delivering, laying, field testing, or disinfecting of pipe and fittings. See AWWA Manual M9, Concrete Pressure
Pipe, for information on these topics. The pipe shall have the following principal features: a welded steel cylinder with sized steel joint rings welded to the ends; a lining of concrete or cement mortar centrifugally applied within the steel cylinder and spigot ring; reinforcement consisting of continuous steel bar helically wound tightly around the outside of the cylinder and securely fastened by welding to the steel joint ring at each end of the cylinder; a coating of dense mortar covering the cylinder and bars, except for the necessarily exposed surfaces of the spigot joint ring; and a self-centering joint with a preformed gasket of rubber, so designed that the joint will be watertight under all conditions of service.
Major revisions made to the standard in this edition include the following:
the format has been changed to reflect current AWWA standard style; the prevailing range in pipe diameters has been changed to 10 in. through 72 in. (250 mm through 1,830 mm); autogenous healing has been added to the definitions (Sec. 3); a second test cylinder size has been added (Sec. 4.6.5.3); the portland-cement slurry concentration and application rate for use with the circumferential bar reinforcement have been revised (Sec. 4.6.6.3); a section on cracks in pipe wall has been added (Sec. 4.6.9); and, a section on repair of concrete or mortar has been added (Sec. 4.6.10).
| ANSI : | ANSI Approved |
| File Size : | 1
file
, 470 KB |
| Note : | This product is unavailable in Ukraine, Russia, Belarus |
| Number of Pages : | 44 |
| Published : | 01/01/2003 |
