1.1 Scope: Requirements in this Standard apply to power assist doors, low energy power
operated doors or low energy power open doors for pedestrian use, and some small vehicular use
and not provided for in ANSI/BHMA A156.10 for Power Operated Pedestrian Doors. Included
are provisions intended to reduce the chance of user injury or entrapment.
1.1.1 This Standard does not attempt to assess any factors that exist with respect to custom
design installations which are not required to meet the requirements of this Standard.
1.2 Required dimensions are expressed in US units first and the SI (metric) equivalents given
in parentheses are approximate. All values which do not carry specific tolerances or are not
marked maximum or minimum shall have the following tolerances: Linear dimensions shall be ?
1/16 in (1.6 mm). Pounds or pound force shall be ? 5%. Angular measurements shall be ? 4
degrees. Voltage measurements shall be ? 5 %. Temperature measurements shall be ? 4 degrees
F (?2 degrees C).
1.3 Definitions of terms used but not found in this Standard are in ANSI/BHMA A156.10 for
Power Operated Pedestrian Doors, available at www.buildershardwre.com and the American
National Standards Institute, Inc., 11 West 42nd Street, New York, NY 10036.
1.4 All references to time delay, opening speed and forces, in this standard, refer to the operator
in the power mode as opposed to the manual mode.
This item is available as part of a discounted standards set covering
Door Controls . | ANSI : | ANSI Approved |
| File Size : | 1
file
, 74 KB |
| Note : | This product is unavailable in Russia, Ukraine, Belarus |
| Number of Pages : | 10 |
| Published : | 04/20/2007 |
