Scope: This document specifies the requirements for solid-wall polyethylene (PE) pipes with smooth internal
and external surfaces extruded from the same compound/formulation throughout the wall, fittings and the system for:
-- soil and waste discharge applications (low and high temperature) inside buildings (application area
code 'B");
-- soil and waste discharge applications (low and high temperature) for both inside buildings and buried in the ground within the building structure (application area code "BD").
NOTE 1 The intended use is reflected in the marking of products by "B" or "BD".
NOTE 2 For use buried in the ground within the building structure are intended only those components marked with "BD", with a nominal ring stiffness of at least SN4 for dimensions equal to or greater than 75 mm.
This document is also applicable to PE pipes and fittings and the system intended for the following purposes:
-- ventilating part of the pipework in association with discharge applications;
-- rainwater pipework within the building structure.
It also specifies the test parameters for the test methods referred to in this standard.
This document covers a range of nominal sizes, a range of pipes and fittings series and gives recommendations concerning colours.
NOTE 3 It is the responsibility of the purchaser or specifier to make the appropriate selections from these
aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes, e.g. CEN/TR 13801 [1].
NOTE 4 Pipes, fittings and other components conforming to any of the plastics product standards listed in
Annex B can be used with pipes and fittings conforming to this European Standard, if applicable.
It applies to pipes and fittings, marked with "B", which are intended to be used inside buildings and
outside buildings fixed onto the wall.
It applies to pipes and fittings, marked with "BD", which are intended to be used for both inside buildings
and buried in the ground within the building structure.
This standard is applicable to PE pipes and fittings of the following types:
-- plain-ended;
-- with integral elastomeric ring seal socket;
-- for butt fusion joints;
-- for electrofusion joints;
-- for mechanical joints
where the fittings can be manufactured by injection-moulding or can be fabricated from pipes and/or mouldings.
NOTE 5 EN 476[2] specifies the general requirements for components used in discharge pipes, drains and
sewers for gravity systems. Pipes and fittings conforming to this standard fully meet these requirements.
NOTE 6 For information about the chemical resistance of PE, guidance is given in ISO/TR 10358[3] and for
rubber materials in ISO/TR 7620[4].
Cross References:EN 12099
EN ISO 13255
EN ISO 1043-1
ISO 4065
EN ISO 13254
EN ISO 1167-1
EN ISO 13259
EN ISO 1167-2
EN ISO 3126
EN ISO 2505
EN 681-1
EN ISO 1133-1
EN 681-2
EN ISO 9969
EN ISO 1183-2
EN ISO 472
EN ISO 13257:2018
EN ISO 11357-6
EN ISO 580
EN ISO 3451-1
EN ISO 13264
EN 12201-2
ISO/TR 7620
EN 12666-1
CEN/TR 13801
ISO/TR 10358
EN 12201-3
EN 476
EN 1555-2
EN ISO 13967
EN ISO 9001
EN 1555-3
ISO 265-1
All current amendments available at time of purchase are included with the purchase of this document. | File Size : | 1
file
, 2.8 MB |
| ISBN(s) : | 9780580994685 |
| Note : | This product is unavailable in Ukraine, Russia, Belarus |
| Number of Pages : | 40 |
| Product Code(s) : | 30364342, 30364342, 30364342 |
| Published : | 05/02/2019 |
