BS EN ISO 11297-2:2018, in conjunction with ISO 11297-1, specifies requirements and test methods for pipes
and fittings which are part of plastics piping systems installed as continuous pipes in the renovation
of underground drainage and sewerage networks under pressure. It is applicable to polyethylene (PE)
pipes of three different types:
- PE solid wall single layered pipes (nominal outside diameter, dn), including any identification stripes;
- PE pipes with co-extruded layers on either or both the outside and inside of the pipe (total outside
diameter, dn), as specified in Annex A, where all layers have the same MRS rating;
- PE coated pipes (outside diameter, dn) having a peelable, contiguous, thermoplastics additional
layer on the outside of the pipe ("coated pipe"), see Annex A.
In addition it covers:
- jointing of pipe lengths by means of butt fusion;
- fabricated and injection-moulded fittings made of PE.
It is applicable to PE pipes, fittings and assemblies intended to be used at an operating temperature of
20 °C as the reference temperature.
Cross References:EN 12201-1
ISO 12176-2
EN 12201-2
ISO 12176-1
ISO 11297-1:2018
ISO 4427-1
ISO 4427-2
EN 12201-3
ISO 4427-3
EN 12201-5
ISO 4427-5
ISO 11295
All current amendments available at time of purchase are included with the purchase of this document. | File Size : | 1
file
, 1.1 MB |
| ISBN(s) : | 9780580885969 |
| Note : | This product is unavailable in Ukraine, Russia, Belarus |
| Number of Pages : | 18 |
| Product Code(s) : | 30315812, 30315812, 30315812 |
| Published : | 03/16/2018 |
| Same As : | BS EN ISO 11297-2:2018 |
