BS EN 846-14. Methods of test for ancillary components for masonry. Part 14. Determination of the initial shear strength between the prefabricated part of a composite lintel and the masonry above it
Document status: Active
BS EN 12201-2. Plastics piping systems for water supply, and for drainage and sewerage under pressure. Polyethylene (PE). Part 2. Pipes
Document status: Active
BS EN 12201-3. Plastics piping systems for water supply, and for drainage and sewerage under pressure. Polyethylene (PE). Part 3. Fittings
Document status: Active
BS EN 13071-3. Stationary waste containers up to 5000 l, top lifted and bottom emptied. Part 3. Recommended lifting connections
Document status: Active
BS EN 15037-5. Precast concrete products. Beam-and-block floor systems. Part 5. Lightweight blocks for simple formwork
Document status: Active
BS ISO 11040-6. Prefilled syringes. Part 6. Plastic barrels for injectables
Document status: Active
BS ISO 13400-1. Road vehicles. Diagnostic communication over Internet Protocol (DoIP). Part 1. General information and use case definition
Document status: Active
BS ISO 13400-3. Road vehicles. Diagnostic communication over Internet Protocol (DoIP). Part 3. IEEE802.3 based wired vehicle interface
Document status: Active
BS ISO 14309. Rubber, vulcanized or thermoplastic. Electrical resistivity. Determination of volume and/or surface resistivity
Document status: Active
