DANSK DS/EN ISO 4064-5 PDF

This Part of ISO 4064 applies to water meters used to meter the volume of cold potable water and hot water flowing through a fully charged, closed conduit. These water meters incorporate devices which indicate the integrated volume. This Part of ISO 4064 specifies criteria for the selection of single, combination, and concentric water meters, associated fittings, installation, special requirements for meters and the first operation of new or repaired meters to ensure accurate constant measurement and reliable reading of the meter. This Part of ISO 4064 also applies to water meters based on electrical or electronic principles, and to water meters based on mechanical principles incorporating electronic devices, used to meter the volume flow of hot water and cold potable water. It also applies to electronic ancillary devices. As a rule ancillary devices are optional. NOTE – However, national or international regulations may make some ancillary devices mandatory in relation to the utilization of the water meter. The recommendations of this part of ISO 4064 apply to water meters, irrespective of technology, defined as integrating measuring instruments continuously determining the volume of water flowing through them. NOTE – Attention is drawn to the fact that national legislation may apply in the country of use, which will take precedence over the provisions of this standard.