DANSK DS/IEC/PAS 62825 PDF

This PAS applies to large plasma display panel TVs intended for use in residential and commercial environments. NOTE – Although this document is applied to plasma display technology, it should be noted that in any future International Standard, or amendment to existing International Standard, it may be necessary to ensure technology neutrality. To this end, users of this document are invited to investigate the compliance of other display technologies with the limits of this document. Depending on the characteristics (voltage, current and size) of other display technologies, users may decide, upon their own discretion, that measurements according to this PAS are not necessary. This PAS covers emission requirements related to radiated radio-frequency (RF) disturbances in the frequency range 150 kHz to 30 MHz. It specifies suitable limits and methods of measurement for the assessment of radiated RF disturbances. The requirements specified in this PAS are essential EMC requirements which should be met in order to protect radio reception in the frequency range up to 30 MHz at locations where these display devices are operated in the field. While application of this PAS is recommended, the comprehensive set of normative EMC emission requirements is found e.g. in CISPR 13 or CISPR 32. Use of this PAS shall not remove the obligation to apply any other CISPR publication. The objectives of this specification are: a. to establish supplementary requirements which provide an adequate level of protection of the radio frequency spectrum, allowing radio reception as intended in the frequency range 150 kHz to 30 MHz b. to specify procedures to ensure the reproducibility of measurement and the repeatability of obtained results.