DANSK DSF/FPRCEN/TS 17286 PDF

The purpose of this Technical Specification is to establish performance benchmarks for, and to evaluate the acceptability of, sorbent trap monitoring systems used to monitor total vapour-phase mercury (Hg) emissions in stationary source flue gas streams. These monitoring systems involve continuous repetitive in-flue sampling using paired sorbent traps with subsequent analysis of the time-integrated samples. This Technical Specification is suitable for both short-term (periodic) measurements and long-term (continuous) monitoring using sorbent traps. the substance measured according to this Specification is the total vapour phase mercury in the flue gas, which represents the sum of the elemental mercury and gaseous forms of oxidised mercury such as mercury (II) chloride, the mass concentration units of micrograms per dry meter cubed. The analysis range is typically 0,1 to greater than 50 µg/m3. The sorbent tube approach is intended for use under relatively low particulate conditions (typically less than 100 mg/m3) when monitoring downstream of all pollution control devices, e.g., at coal fired power plants and cement plants. In this case, the contribution of mercury in the particulate fraction is considered to be negligible (typically less than 5 % of total mercury). However, it shall be noted that the sorbent trap does take account of the finest particle fraction that is sampled with the flue gas, in addition to capturing the vapour phase mercury. This Specification also contains routine procedures and specifications that are designed to evaluate the ongoing performance of an installed sorbent trap monitoring system. The operator of the industrial installation is responsible for the correct calibration, maintenance and operation of this long-term sampling system. Additional requirements for calibration and quality assurance of the long-term sampling system are then defined in EN 14884 and EN 14181.