DANSK DSF/ISO/FDIS 8100-30 PDF

This part of ISO 8100 specifies the necessary dimensions to permit the installation of passenger lifts of class I, II, III and VI. The dimensions given reflect the requirements for the apparatus. This part of ISO 8100 is applicable to all new lift installations, irrespective of drive systems, including a car with one entrance, to be installed in a new building. However, for arrangements with counterweight at the side, a through-entrance configuration is possible. Where relevant, this part of ISO 8100 is also applicable to an installation in an existing building. This part of ISO 8100 is not applicable to lifts of rated speed greater than 6,0 m/s. NOTE – It is the responsibility of the user to consult the manufacturer for such installations. 2 Terms and definitions For the purposes of this part of ISO 8100, the following terms and definitions apply. 2.1 General 2.1.1 car part of the lift which carries the passenger and/or other loads 2.1.2 head room part of the well situated above the highest landing served by the car 2.1.3 landing area providing access to the car at each level of use 2.1.4 machine room room in which the machine or machines and/or the associated equipment are placed 2.1.5 machine room-less lift lift whose machinery spaces, e.g. control cabinet(s) and drive system, lift machine, main switch(es), and means for emergency operations, are inside the well or on the landing(s) 2.1.6 lift GB elevator US permanent lifting appliance serving defined landing levels, comprising a car, the dimensions and means of construction of which, clearly permit the access of passengers