DIN EN 13774 PDF

Published Date: 05/01/2013

Valves for gas distribution systems with maximum operating pressure less than or equal to 16 bar - Performance requirements

Published Date: 05/01/2011

Draft Document - Valves for gas distribution systems with maximum operating pressure less than or equal to 16 bar - Performance requirements; German version EN 13774:2011

Published Date: 07/01/2003

Valves for gas distribution systems with maximum operating pressures less than or equal to 16 bar - Performance

Published Date: 08/01/2023

Non-soldering compression couplings - Elbow body

Published Date: 07/01/2004

Adjusting nuts for pressure gauges and their accessories

Published Date: 10/01/2024

District heating pipes - Bonded single pipe systems for directly buried hot water networks - Factory made pipe assembly of steel service pipe, polyurethane thermal insulation and a casing of polyethylene (includes Amendment :2023)

Published Date: 07/01/2024

Rubber hoses, textile-reinforced, for compressed air - Specification (ISO 2398:2024)

Published Date: 09/27/2006

Advanced technical ceramics — Ceramic composites. Methods of test for reinforcements — Part 7: Determination of the distribution of tensile strength and of tensile strain to failure of filaments within a multifilament tow at high temperature

Published Date: 06/22/2021

Thermoplastics piping and ducting systems - Outside the building structures for gravity and pressurised systems - Trench installation

Published Date: 07/21/2004

Advanced technical ceramics — Methods of test for ceramic coatings — Part 10: Determination of coating thickness by cross sectioning

Published Date: 10/19/2005

Advanced technical ceramics — Methods of test for ceramic coatings — Part 11: Determination of internal stress by the Stoney formula

Published Date: 09/01/2004

Advanced technical ceramics — Methods of test for ceramic coatings — Part 8: Rockwell indentation test for evaluation of adhesion

Published Date: 02/11/2004

Advanced technical ceramics — Methods of test for ceramic coatings — Part 9: Determination of fracture strain