GME GME R-0-19 PDF

Introduction

Note: Nothing in this standard supersedes applicable laws and regulations.

Note: In the event of a conflict between the English and the domestic language, the English language shall take precedence.

Purpose. The schedule is intended to cover customer use in countries with developing road systems like i.e. in South America and Asia. It serves as a durability test for the entire vehicle and/or the experimental components installed in the vehicle.

Comparable test results can be achieved by application of the respective route description also on the following proving grounds:

PG Cruz Alta (GM do Brasil). Route description GMI R021.

PG Lang Lang (GM Holden). Route description GMI R022.

PG Millbrook (Vauxhall). Route description GMI R023.

Foreword. The schedule is based on schedule GME R-0-17 and corresponds approximately to the use of GMB G4. In comparison with GME R-0-17, less severe sections have been replaced by more severe sections, and the speeds have been partly increased. Average severity factor in comparison with GME R-0-17: 4 times 4. The structural input represents GMW3425.

Applicability. For all passenger cars, worldwide intended.

Schedule G0 (GME R-0-19) may be run either with or without salt splash / mist passages.

Definitions.

4WD = Four-wheel drive

E1 = Durability Road according to GMW15443

G0 = Durability Road according to GME R-0-19

G1 = Durability Road according to GMW15531