INTERN MPAPS S-FM-1.301-GS/PL PDF

GENERAL: Implementation of this standard must be in accordance with the policies and procedures outlined in MPAPS S-A-0.101. There may also be supplemental group instructions in regard to use of metric standards that should be taken into account.

This standard may differ in some respects with certain segments of national standards. In recognition of these differences, the sizes and tolerance ranges used were established in an effort to enable the use of commercially available items, dimensionally interchangeable worldwide.

This specification contains the essentials of the following standards:

German Institute Standardization: DIN 6797

It should be noted that the word "Lock" appearing in the names of the products in this standard is a generic term historically associated with their identification and is not intended to imply an indefinite permanency of fixity in attachments where they are used.

The inclusion of dimensional data is not intended to imply that all the washers described are stock production sizes.

Inch dimensioned standard washers may be found in MPAPS S-F-1.301-GS/PL