INTERN MPAPS S-FM-16.101-GS/PL PDF

GENERAL: Implementation of this standard must be in accordance with the policies and procedures outlined in MPAPS S-A-0.101. There may also be divisional supplemental instructions in regard to use of metric standards that should be taken into account.

Some segments of the ISO and national standards encompassed by this general specification differ. In recognition of these differences, the sizes and tolerance ranges used were established in an effort to enable the use of commercially available items, dimensionally interchangeable worldwide.

This specification contains the essentials of the following standards:

International Organization for Standardization: ISO R887

Association of French Standards: NF E27-611

British Standards Institute: BS 4320

German Institute of Standardization: DIN 125

Standards Association of Australia: AS 1237

The inclusion of dimensional data is not intended to imply that all the washers described are stock production sizes.

Inch dimensioned standard carbon steel washers may be found in MPAPS S-F-15.101-GS/PL and hardened washers in MPAPS S-F-16.101-GS/PL.