INTERN MPAPS S-JM-1.101-GS/PL PDF

GENERAL: Implementation of this standard must be in accordance with the policies and procedures outlined in MPAPS S-A-0.101. There may also be supplemental group instructions in regard to use of metric standards that should be taken into account.

In formulating this standard for metric split pins, considerable investigation was devoted to an effort to establish interchangeability with the inch series pins in order to avoid the creation of separate part numbers, records, inventories, etc. However, significant dimensional differences in most sizes, primarily in head dimensions and recommended hole sizes, preclude this possibility. This specification contains the essentials of the following standards:

This specification contains the essentials of the following standards:

International Organization for Standardization: ISO R 1234

Association Francaise de Normalisation: NF E27-487

British Standards Institute: BS 1574

Deutsche Normen: DIN 94

Standards Association of Australia: AS 1236

The inclusion of dimensional data is not intended to imply that all the pins described are stock production sizes.

Inch series split (cotter) pins may be found in MPAPS S-J-1.101-GS/PL.