This paper presents a new method to detect and eliminate rear gouging in five-axis machining of sculptured surfaces. The method is based on finding accurate swept sections of flat-ended tools. The proposed swept sections, two dimensional representations of the geometry of the moving tool, enable the gouge detection and elimination calculations to be done in two dimensions, thereby reducing complexity.
Thermoplastics piping and ducting systems - Outside the building structures for gravity and pressurised systems - Trench installation; German version CEN/TS 1046:2021
Advanced technical ceramics - Ceramic composites - Thermophysical properties - Part 4: Determination of thermal conductivity; German version CEN/TS 1159-4:2004
Wood preservatives - Field test method for determining the relative protective effectiveness of a wood preservative exposed out of ground contact - Horizontal lap-joint method; German version CEN/TS 12037:2003
Cookware - Domestic cookware for use on top of a stove, cooker or hob - Part 2: Further general requirements and specific requirements for ceramic, glass and glass ceramic cookware; German version CEN/TS 12983-2:2005
