By order of the publisher, historical UL documents are not returnable for any reason. Once you place an order for an historical document, we cannot issue a refund, credit, or exchange of any kind.These requirements cover telecommunications-circuit accessories, such as jack and plug assemblies, quick-connect terminal assemblies, telephone wall plates,
telephone extension cords, cross-connect terminal-block assemblies, maintenance terminal modules, terminal enclosures, cable-splice enclosures, network-interface
devices, wire-guide assemblies, and connector boxes.
These devices are intended to be used in telecommunications networks that have an operating root-mean-square (rms) voltage to ground less than 150 volts and
installed or used in accordance with the National Electrical Code, ANSI/NFPA 70.
These requirements do not cover telephone equipment such as telephone answering devices, residential telephone instruments, telephone dialers, cordless phones,
key systems, and private-branch exchange equipment that is covered by the Standard for Telephone Equipment, UL 1459. Also, these requirements do not cover:
- Telephone protectors that are covered by the Standard for Protectors for Paired Conductor Communications Circuits, UL 497, and
- Secondary protectors.
These requirements do not cover cellular telephones or other receiver/transmitter-type devices. Equipment of this type is covered by the Standard for Radio
Receivers, Audio Systems, and Accessories, UL 1270.
These requirements may be used, directly or by reference, to investigate portions of other equipment, not classified as telecommunications-equipment accessories,
that may be connected to a telecommunications network, insofar as they may be applicable to such equipment.
These requirements do not cover wires and cables intended to be permanently installed in a building in accordance with Article 800 of the National Electrical Code,
ANSI/NFPA 70.
A product that contains features, characteristics, components, materials, or systems new or different from those covered by the requirements in this standard, and that
involves a risk of fire or of electric shock or injury to persons shall be evaluated using appropriate additional component and end-product requirements to maintain
the level of safety as originally anticipated by the intent of this standard. A product whose features, characteristics, components, materials, or systems conflict with
specific requirements or provisions of this standard does not comply with this standard. Revision of requirements shall be proposed and adopted in conformance with
the methods employed for development, revision, and implementation of this standard.
| Edition : | 3rd |
| Published : | 01/01/2000 |
