ASTM D3032-21 PDF

1.1''These test methods cover procedures for testing hookup wire.

1.2''For the purposes of these test methods, hookup wire insulation includes all components of the insulation system used on single insulated conductors or an assembly of single insulated conductors such as a cable bundle and harness or flat ribbon cable. The insulating materials include not only the primary insulation over the conductor, but also insulating jackets over shielded constructions.

1.3''These test methods and their locations are as follows:

''

Section

Axial Stability (Longitudinal Change) After Thermal Exposure

21

Bondability of Insulation to Potting Compounds

19

Capacitance

9 to 12

Cold Bend Test

26

Concentricity

26

Crush Resistance

20

Dielectric Breakdown Voltage

5

Dimensions

15

Dry-arc Tracking

29

Dynamic Cut-through

22

Fluid Immersion

23

High Temperature Shock

24

Insulation-Continuity Proof Tests

13

Insulation Resistance

6

Partial Discharge (Corona) Inception and Extinction Voltage

25

Relative Thermal Life and Temperature Index

14

Strip Force

27

Surface Resistance

27

Tensile Properties

17

Vertical Flame

18

Vertical Flame Test A

18.5
(Test Method D8354)

Vertical Flame Test B

18.6 ''' 18.11.4

Voltage Rating of Hook-Up Wire

Annex A1

Voltage Withstand Test

8

Wet Arc-tracking

28

1.4''The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.5''This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not, by itself, incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.6''Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

1.7''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 12.2.1, 12.4.1.8, 18.1.3, 25.4, and Note 19.

1.8''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

File Size :	1 file , 910 KB
Note :	This product is unavailable in Russia, Ukraine, Belarus
Number of Pages :	40
Published :	01/01/2021
Redline File Size :	2 files , 2 MB