ASTM D3032-21a PDF

1.1''These test methods cover procedures for testing hookup wire.

1.2''For the purposes of these test methods, hookup wire insulation includes all components of the insulation system used on single insulated conductors or an assembly of single insulated conductors such as a cable bundle and harness or flat ribbon cable. The insulating materials include not only the primary insulation over the conductor, but also insulating jackets over shielded constructions.

1.3''These test methods and their locations are as follows:

''

Section

Axial Stability (Longitudinal Change) After Thermal Exposure

20

Bondability of Insulation to Potting Compounds

18

Capacitance

9 to 11

Cold Bend Test

25

Concentricity

25

Crush Resistance

19

Dielectric Breakdown Voltage

5

Dimensions

14

Dry-arc Tracking

28

Dynamic Cut-through

21

Fluid Immersion

22

High Temperature Shock

23

Insulation-Continuity Proof Tests

12

Insulation Resistance

6

Partial Discharge (Corona) Inception and Extinction Voltage

24

Relative Thermal Life and Temperature Index

13

Strip Force

26

Surface Resistance

26

Tensile Properties

16

Vertical Flame

17

Vertical Flame Test A

18.5
(Test Method D8354)

Vertical Flame Test B

17.6 ''' 17.11.4

Voltage Rating of Hook-Up Wire

Annex A1

Voltage Withstand Test

8

Wet Arc-tracking

27

1.4''The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.5''This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not, by itself, incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.6''Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

1.7''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 17.1.3, 24.4, and Note 18.

1.8''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.