AWS A5.29/A5.29M PDF

This specification prescribes requirements for the classification of low-alloy steel electrodes for flux cored arc welding (FCAW) either with or without shielding gas. With two exceptions, the 20% manganese types “Mn1” and “Mn2,” iron is the only element whose content exceeds 10.5% in undiluted weld metal deposited by these electrodes.

This specification makes use of both U.S. Customary Units and the International System of Units (SI). The measurements are not exact equivalents; therefore, each system must be used independently of the other without combining in any way when referring to weld metal properties. The specification with the designation A5.29 uses U.S. Customary Units. The specification A5.29M uses SI Units. The latter are shown within [brackets] or in appropriate columns in tables and figures. Standard dimensions based on either system may be used for the sizing of electrodes or packaging or both under the A5.29 and A5.29M specifications.

Safety and health issues and concerns are beyond the scope of this standard; some safety and health information is provided, but such issues are not fully addressed herein. Some safety and health information can be found in Clauses A5 and A11 in Annex A.

Safety and health information is available from the following sources:

American Welding Society:

ANSI Z49.1, Safety in Welding, Cutting, and Allied Processes

AWS Safety and Health Fact Sheets

Other safety and health information on AWS website

Material or Equipment Manufacturers:

Safety Data Sheets supplied by material manufacturers

Operating Manuals supplied by equipment manufacturers

Applicable Regulatory Agencies

Work performed in accordance with this standard may involve the use of materials that have been deemed hazardous and may involve operations or equipment that may cause injury or death. This standard does not purport to address all safety and health risks that may be encountered. The user of this standard should establish an appropriate safety program to address such risks as well as to meet applicable regulatory requirements. ANSI Z49.1 should be considered when developing the safety program.