AWS C4.2/C4.2M PDF

This standard describes the equipment, procedures and safe practices for the oxyfuel cutting of steel. It is for the operators of both hand and machine torches and is recommended for management personnel associated with the oxyfuel cutting process.

Oxyfuel gas cutting is a process whereby a metal (usually an iron base alloy) is heated to its kindling temperature (well below the melting point) by an oxyfuel gas flame and then burned rapidly by a regulated jet of oxygen. A cutting torch is used for this operation.

This standard makes use of both U.S. Customary Units and the International System of Units (SI). The latter are shown within brackets ([ ]) or in appropriate columns in tables and figures.The measurements may not be exact equivalents; therefore, each system must be used independently.

Although many references are made to safe practices throughout this standard, it is strongly recommended that operators become thoroughly familiar with all aspects of safe operation. Safety and health information is available from various sources, including, but not limited to, ANSI Z49.1, Safety in Welding, Cutting, and Allied Processes, and applicable federal, state, and local regulations.