ASTM C1737-22 PDF

1.1 This guide covers the general effects of temperature from the aerosol foam sealant (either polyurethane or latex types) under the use temperatures.

1.2 The guide is intended to estimate the observed product dispensing characteristics and foam quality of aerosol foam dispensed or cured, or both, at specific temperatures and standard conditions.

1.3 Such foam sealants are primarily intended to reduce air movement in and out of building enclosures.

1.4 Currently two main foam sealant types are applicable to this standard: single component polyurethane and latex.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 There are no other known test methods specific for measuring the product temperature range for aerosol foam sealant.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.